GIFT CERTIFICATES $5.95 SHIPPING ENTER TO WIN  
 
 
Coralvue RO/DI 100gpd System
Other products by CoralVue

 
Item #: RO-CV-RODI
Our Price: $324.99
Availability: Back Order, Available in 2-3 Weeks
Quantity:
 

Coralvue RO/DI 100gpd System.

CoralVue has assembled a high quality water purifying system that turns ordinary tap water into pure aquarium water - efficiently. With this filtration unit you can be assured that your aquatic animals are enjoying the highest quality water possible. 

System Features

  • Easy to use system controller
  • Fully-Automated water management
  • Accurate Digital TDS readings of outgoing product water
  • Automatic membrane flush system prevents TDS creep Cyclic Membrane Flush (Full Membrane Flush upon shutdown to help prevent membrane scaling)
  • Back-pressure electronic shut-off for reservoir use
  • High and low pressure safety kill switches (For pump protection and full system automation)
  • Audible Alarm
  • Filter change notifications
  • Room temperature read out
  • Tested to obtain ~1:3 Product/Waste water ratio (source water temperature dependent)
  • Over-sized  liquid filled pressure gauge
  • High efficiency booster pump
  • Clear filter canisters with silicone o-ring seals
  • Rugged metal frame for convenient free-standing placement or for space saving wall mounting

Technical Data

  • Footprint 14.75" x 9"
  • Height 17.5"
  • 1 100 GPD membrane
  • 1 µ polypropylene sediment cartridge
  • 5 µ carbon block cartridge
  • 1 refillable DI cartridge with high capacity color changing resin
  • Quiet booster pump (located lost pre-filtration for extended pump life)
  • Includes canister & membrane wrench, detailed instructions, installation connection fittings, RO tubing and accessories.
  • All standard 10” canisters, cartridges and ¼"push-connect fittings

Reviews

Average Rating:
(based on 1 review)

Showing 1 Review:

by David
on 7/14/2013
Water pressure (psi) requires constant attention
It produces very pure water and is quiet. Problems I've seen with it: - The instructions for it are VERY poorly translated (from Chinese?). - The instructions reference buttons on the control screen that aren't even labeled the same - The water pressure requirement is 40 - 100 psi, but the recommended pressure is 80 psi. The psi is regulated with a ball-valve type thing in line just before waste water output. It would be great if you could just adjust the psi and then forget about it. But the psi fluctuates constantly, back and forth, higher and lower than 80 psi. This requires constant attention; I go check and adjust it about every 30 minutes. - The screen is one of those that you must look at directly to see the symbols and numbers; if you look at it from an angle (up, down, or from the sides), it looks like a blank green screen. - It's produced about 90 gallons so far, and already the DI resin has changed from black to that rusty orange/red color about a third the way up already.
Review and Rate this Item

Other Items In This Category

SSL Certificate Provider