Abyzz 3rd-Party 0-10V Controller Interface
Connect your Abyzz pump to a HYDROS WaveEngine 0-10V INPUT controller with this simple to install interface and use Fusion to do all your programming for 24-hour cycles, enable feed modes, and apply warnings and alarms.
Connecting the Abyzz to Neptunes Apex Interface is very simple. All that is required is an open variable speed port on an Apex System or expansion module. The RJ45 connector will plug directly into the variable speed port on the APEX system, and then the serial port should be connected to the master socket of the Abyzz pump driver.
NOTE: Not Compatible with Abyzz IPU Pumps
Specifications
- Rated Input -1w max
- Operating Voltage - 5VDC
- RJ45 to Serial Cable Length - 60 inches
- Serial to Serial Extension Cable Length - 72 inches
- NOTE: Not Compatible with Abyzz IPU Pumps
What's Included?
- 1x Serial to RJ45 Cable
- 1x Serial to Serial Extension Cable
NOTE: Depending on your model of pump, a driver software update may be required. Also compatible with Neptune APEX Controller.
Item No. WP-AZ-APEXINT
