Milwaukee MC410 TDS Monitor.
The MC Monitors are designed to continuously monitor pH, EC or TDS values directly in your reservoir. Each unit features a user selectable set-point. An LED visual alarm is activated and flashes when the pH, EC or TDS level rises either Above or Below (user selected) that set-point.
All these instruments run on a 12V adapter so there's no need to worry about failed batteries and each unit comes with mounting kit, probe, probe holder and starter calibration solution.
TDS - PPM Monitor
- User selectable Hi/Low Set Point
- Manual 1 point calibration
- Visual LED alarm
- Supplied with 12 VDC adapter, mounting kit, and 20ml 1382ppm calibration solution
- MA81/2 PPM Probe with 2m cable (BNC connector)
|Range||0 - 1990 ppm|
|Accuracy||±2% Full Scale|
|Setpoint range||700 - 1800 ppm|
|Calibration ||Manual 1 point|
|Alarm||Active when reading is higher or lower than set point|
Questions on Milwaukee MC410 TDS Monitor
No questions asked yet