|
|
|
|
|
|
|
|
 |
Color: White
John Guest Part# : CI0208W
Tube O.D.: 1/4"
Tube O.D.: 1/4"
Tube O.D.: 1/4"
How to make a connection:
* Cut tube square
It is essential that the outside diameter be free of score marks and that burrs and sharp edges be removed before inserting into fitting. For soft or thin walled plastic tubing we recommend the use of a tube insert.
* Insert tube
Fitting grips before it seals. Ensure tube is pushed in to the tube stop.
* Push up to tube stop
Push the tube into the fitting, to the tube stop. The collet (gripper) has stainless steel teeth which hold the tube firmly in position while the "O" ring provides a permanent leak proof seal.
* Pull to check secure
Pull on the tube to check it is secure. It is good practice to test the system prior to leaving site and/or before use.
Disconnecting:
Push in Collet and remove tube
To disconnect, ensure the system is depressurized before removing fitting. Push in Collete squarely against face of fitting. With the Collete held in this position, the tube can be removed. The fitting can then be re-used.
|
 |
| 1 Customer Review |
| 5 Star: |
 |
1 |
Average Customer Rating
 5.0
out of 5 100% recommend it to
friends
|
| 4 Star: |
|
0 |
| 3 Star: |
|
0 |
| 2 Star: |
|
0 |
| 1 Star: |
|
0 |
|
|
|
|
by
from
new brunswick canada
on
3/23/2009
Recommends it to Friends:
Yes
I've used no name push to connect fittings that always leak.
JG fittings never leak even after repeated use
Was this review helpful to you? YES /
NO
|
|
|
|
|