Milwaukee MC410 TDS Monitor.
The MC Monitors are designed to continuously monitor pH, EC or TDS values directly in your reservoir. Each unit features a user selectable set-point. An LED visual alarm is activated and flashes when the pH, EC or TDS level rises either Above or Below (user selected) that set-point.
All these instruments run on a 12V adapter so there's no need to worry about failed batteries and each unit comes with mounting kit, probe, probe holder and starter calibration solution.
TDS - PPM Monitor
- User selectable Hi/Low Set Point
- Manual 1 point calibration
- Visual LED alarm
- Supplied with 12 VDC adapter, mounting kit, and 20ml 1382ppm calibration solution
- MA81/2 PPM Probe with 2m cable (BNC connector)
Milwaukee MC410 TDS Monitor.
The MC Monitors are designed to continuously monitor pH, EC or TDS values directly in your reservoir. Each unit features a user selectable set-point. An LED visual alarm is activated and flashes when the pH, EC or TDS level rises either Above or Below (user selected) that set-point.
All these instruments run on a 12V adapter so there's no need to worry about failed batteries and each unit comes with mounting kit, probe, probe holder and starter calibration solution.
TDS - PPM Monitor
- User selectable Hi/Low Set Point
- Manual 1 point calibration
- Visual LED alarm
- Supplied with 12 VDC adapter, mounting kit, and 20ml 1382ppm calibration solution
- MA81/2 PPM Probe with 2m cable (BNC connector)
| SPECIFICATIONS | |
| Range | 0 - 1990 ppm |
| Resolution | 10 ppm |
| Accuracy | ±2% Full Scale |
| Setpoint range | 700 - 1800 ppm |
| Calibration |
Manual 1 point |
| Alarm | Active when reading is higher or lower than set point |
| Probe | MA812/2 (included) |
Item No. TE-MC410
