847-775-0640 Call us M-F 9-5:30 CST

John Guest 1/4" x 1/4" Bulkhead

Product code: 969

Availability: In stock

Ships today if ordered in the next 11 hours and 13 minutes!

Reward Points Policy You will earn 297 AQUAPOINTS for buying this product.

John Guest 1/4" x 1/4" BulkheadTube O.D.: 1/4"
Tube O.D.: 1/4"

John Guest 1/4" x 1/4" Bulkhead

John Guest Part# : PI1208S
Tube O.D.: 1/4"
Tube O.D.: 1/4"

How to make a connection:

* Cut tube square
It is essential that the outside diameter be free of score marks and that burrs and sharp edges be removed before inserting into fitting. For soft or thin walled plastic tubing we recommend the use of a tube insert.
* Insert tube
Fitting grips before it seals. Ensure tube is pushed in to the tube stop.
* Push up to tube stop
Push the tube into the fitting, to the tube stop. The collet (gripper) has stainless steel teeth which hold the tube firmly in position while the "O" ring provides a permanent leak proof seal.
* Pull to check secure
Pull on the tube to check it is secure. It is good practice to test the system prior to leaving site and/or before use.


Push in Collet and remove tube

To disconnect, ensure the system is depressurized before removing fitting. Push in Collete squarely against face of fitting. With the Collete held in this position, the tube can be removed. The fitting can then be re-used.

Questions on John Guest 1/4" x 1/4" Bulkhead

  • From Mark at 1/28/2015 8:10 PM
    • What size hole do I need to drill to fit this bulkhead?
    • Mark, you will need to use 5/8" drill bit.
    • Do you find this question helpful?  Yes   No

Ask Your Own Question

  1. Nice product. Review by Robert
    Product Rating:

    Would like it even better if it came in different lengths to better fit different aquariums/sumps. (Posted on 10/8/2014)

Write Your Own Review

You're reviewing: John Guest 1/4" x 1/4" Bulkhead

How do you rate this product? *

Product Rating: 1 stars 2 stars 3 stars 4 stars 5 stars
5.95 In stock